eltech GsmAlarm-500, Manual

Page: 37 / 63

P R O G R A M M I N G
_________________________________________________________________________________
GsmAlarm-500
Software ver. 1.15
-
33-
5.7.7.
PARAMETER “P”: PARTITION ASSIGNMENT AND PARTIAL ARM METHODS.
TAMPER RECOGNITION
This parameter is defining if zone is operating in full or partial protection mode. Also, whether
tamper recognition is activated. Possible operating modes are described in detail in Chapter 5.3.1.3.
Default values for all zones programmed by manufacturer: 10.
5.7.8.
PARAMETER “I”: PULSE COUNTING MODE OR TEMPERATURE
HYSTERESIS
If the first digit of this parameter is larger than 1, the zone operates in the pulse counting mode. After
triggering of a zone the number of times Ni during the preset time Ti, the system switches over to the
alarm state. The first digit: the number of triggering events Ni. The second digit: the pulse counting
time Ti. Multiplication of the second number by 10 produces the time in seconds. Minimal time: 10
seconds (1), maximal time: 90 seconds (9). If Ni=0 or Ni=1, the pulse counting mode is switched off.
In temperature measuring mode this parameter comply temperature difference, at which triggered
zone returns to primary state.
The factory default values for all zones: 02.
Address Parameter
281 Zone Z1 „P“ parameter
282 Zone Z2 „P“ parameter
283 Zone Z3 „P“ parameter
284 Zone Z4 „P“ parameter
285 Zone Z5 „P“ parameter
286 Zone Z6 „P“ parameter
287 Zone Z7 „P“ parameter
288 Zone Z8 „P“ parameter
Address Parameter
289 Zone Z9 „P“ parameter
290 Zone Z10 „P“ parameter
291 Zone Z11 „P“ parameter
292 Zone Z12 „P“ parameter
293 Zone Z13 „P“ parameter
294 Zone Z14 „P“ parameter
295 Zone Z15 „P“ parameter
Address Parameter
331 „I“ parameter of zone Z1
332 „I“ parameter of zone Z2
333 „I“ parameter of zone Z3
334 „I“ parameter of zone Z4
335 „I“ parameter of zone Z5
336 „I“ parameter of zone Z6
337 „I“ parameter of zone Z7
338 „I“ parameter of zone Z8
Address Parameter
339 „I“ parameter of zone Z9
340 „I“ parameter of zone Z10
341 „I“ parameter of zone Z11
342 „I“ parameter of zone Z12
343 „I“ parameter of zone Z13
344 „I“ parameter of zone Z14
345 „I“ parameter of zone Z15