S Y S T E M
C O N T R O L
_________________________________________________________________________________
GsmAlarm-500
Software ver. 1.15
-
54-
It is possible temporarily to turn off chosen zone by commands 01# - 16# (for example, in the case of
sensor fault, if system is constantly sending wrong alarm messages). In order to turn off zone Z1, code
01# is entered. In order to turn off zone Z12, code 12# is entered. Command 00# turns off BYPASS
mode for the all zones.
Further listed commands are used for system programming by SMS message.
SMS instruction
Function
ZPARAM
Request to send SMS message with input Z1-Z5 parameters.
CPARAM
Request to send SMS message with output C1, C2 and BELL parameters.
RPARAM
Request to send SMS message with names of the protected objects
(partition names).
NRINFO
Request to send SMS message with user numbers ALRNR1 – ALRNR5.
PASSW:
SMS password change instruction.
ALRNR1:
ALRNR2:
ALRNR3:
ALRNR4:
ALRNR5:
User numbers programming instructions.
ADDNR:
Additional user numbers programming instruction (for gate or fence
control).
ADDNR-C0:
Additional user number programming instruction. This number can control
all outputs by short tone command (only for gate or fence control).
ADDNR-C1:
Additional user number programming instruction. Only the output C1 is
controlled by this number (for gate or fence control).
ADDNR-C2:
Additional user number programming instruction. Only the output C2 is
controlled by this number (for gate or fence control).
ADDNR-C3:
Additional user number programming instruction. Only the output C2 is
controlled by this number (for gate or fence control).
ADDNR-C4:
Additional user number programming instruction. Only the output C4 is
controlled by this number (for gate or fence control).
DELNR:
Additional user numbers erasing instructions.
NRLIST
Request to send SMS message (messages) with all numbers stored in SIM
card.
SCLOCK
System clock control and time setting instruction.
TSINCH
Automatic time synchronization instruction.
STIMER
Request to send SMS message with system timer parameters.
CIDACC
CONTACT ID user account number programming instruction (audio
channel).
ZOPTXT:
Programming of the word informing that zone is in alarm state (open).
Default: ALARM (see Ch. 5.4).
ZCLTXT:
Programming of the word informing that zone isn’t in alarm state (closed).
Default: OK (see Ch. 5.4).
GETIPA
Activation of GPRS connection (server mode), request to send SMS with
GSM module IP address and connection port number.
CONNECT
Activation of GPRS connection (client mode), request to send SMS with
computer IP address and connection port number.
APN:
GPRS access point name programming.
APLOG:
Programming of GPRS access point login name.
APPASS:
Programming of GPRS access point login password.
PORT:
GPRS access port number programming
