Elnec SEEprog, User Manual

Page: 64 / 171

ELNEC s. r. o.
•
When connecting the programmer to the PC: FIRST insert the communications cable
and THEN the power-supply connector.
•
When disconnecting the programmer from the PC: FIRST disconnect the power-supply
connector and THEN the communication cable .
Problems related to the SEEprog PC interconnection, and their
removing
The LPT port have to be set to SPP (standard parallel port) mode. In some cases BIOS of
computer don't allow to switch proper mode by software, therefore we recommend to do it
manually. If you have any problems with SEEprog
PC interconnection, see section
Common notes please.
Manipulation with the programmed device
After selection of desired device for your work, you can insert into the open ZIF socket (the
lever is up) and close socket (the lever is down). The correct orientation of the programmed
device in ZIF socket is shown on the picture near ZIF socket on the programmer's.
Only 8
bottommost pins of the DIL14 ZIF socket are active! The programmed device is
necessary to insert into the socket also to remove from the socket when LED BUSY light off.
Warning ! SEEprog programmer hasn’t protection devices, which protect the content of
programmed device against critical situations, for example power failures and PC failure
(interrupted cable...). Moreover, a device is usually destroyed in the programming mode due
to forced interruption of the control program run (Reset or switching the computer off) due to
removing the connecting cable, or unplugging the programmed device from the ZIF socket.
Incorrectly placed device in the ZIF socket can cause its damage or destruction.
Technical specification
HARDWARE
Socket and control of pins:
•
DIL/ZIF socket (300mil)
•
each pin is possible to set in position Low and Pull-up
•
from each pin is possible to read
•
support of Low Voltage devices
For works with serial EEPROM are used nearest 8 pins to lever, unused pins are not
connected.
DEVICE SUPPORT
•
EEPROM IIC (24Cxxx)
•
EEPROM Microwire (93Cxxx)
•
EEPROM SPI (25Cxxx)
•
specially devices (digital thermometers, ...)
Note:
64