Elnec SEEprog, User Manual

Page: 39 / 171

BeeProg2 / BeeProg2C /
Calibration test
•
Insert 48 Pins Calibration test POD, Type I into ZIF socket of the programmer. 48 Pins
Calibration test POD, Type I must be inserted as 48 pins device.
•
Run calibration test of programmer in PG4UW (Programmer / Calibration test).
Technical specification
HARDWARE
Base unit, DACs
•
USB 2.0 high-speed compatible port, up to 480 Mb/s transfer rate
•
FPGA based IEEE 1284 slave printer port, up to 1MB/s transfer rate (except BeeProg2C)
•
on-board intelligence: powerful microprocessor and FPGA based state machine
•
three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
•
VCCP range 0..8V/1A
•
VPP1, VPP2 range 0..26V/1A
•
selftest capability
•
protection against surge and ESD on power supply input, parallel port connection
•
banana jack for ESD wrist straps connection
•
banana jack for connection to ground
Socket, pindriver
•
48-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 48-pin
•
pindrivers: 48 universal
•
VCCP / VPP1 / VPP2 can be connected to each pin
•
perfect ground for each pin
•
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
•
analog pindriver output level selectable from 1.8 V up to 26V
•
current limitation, overcurrent shutdown, power failure shutdown
•
ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)
•
continuity test: each pin is tested before every programming operation
ISP connector
•
20-pin male type with miss insertion lock
•
6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to
5V to handle all (low-voltage including) devices.
39