Elnec SEEprog, User Manual

Page: 63 / 171

SEEprog
SEEprog elements
1) 14 pin ZIF socket. Only 8 bottommost pins are active, as shown at the picture at the left.
2) power
LED
3) LPT connector for PC
↔
SEEprog communication cable
4) work result LED
5) Power supply connector
Power supply connector
+
Connecting SEEprog programmer to PC
Switch off the PC and programmer. Insert the connection cable, included in the SEEprog
programmer delivery, to the free printer port of PC. If your computer is equipped with only one
printer port, substitute the programmer cable for the printer cable. Connect the opposite cable
end to the programmer. Screw on both connectors to counter connectors. This is very
important mainly for the connector to programmer. Though replacing the printer cable by the
programmer cable is uncomfortable, it is not recommended to operate the SEEprog
programmer through a mechanical printer switch. Use of an electronic printer switch isn't
possible.
Connect the mains connector of the power supply (or wall-plug power supply self) to a mains
plug, connect the connector to the appropriate programmer's connector. Then, on the
programmer lights up LED POWER and the programmer SEEprog is ready to run. Next
switch on the PC and run the control program.
Caution! If you don't want to switch off your PC when connecting the SEEprog, proceed as
follows:
63