
ELNEC s. r. o.
•
1x VCCP voltage (range 2V..7V/100mA)
•
programmed chip voltage (VCCP) with both source/sink capability and voltage sense
•
and 1x VPP voltage (range 2V..25V/50mA)
•
Target system power supply voltage (range 2V..6V/250mA)
•
ESD protection on each pin of ISP connector (IEC1000-4-2: 15kV air, 8kV contact)
•
two output signals, which indicate state of work result = LED OK and LED Error (active
level: min 1.8V)
•
input signal, switch YES! equivalent (active level: max 0.8V)
DEVICE SUPPORT
Programmer, in ZIF socket
•
EPROM: NMOS/CMOS, 27xxx and 27Cxxx series, with 8/16 bit data width, full support for
LV series
•
EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series, with 8/16 bit data width
•
Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx, 29Wxxx, 49Fxxx series,
Samsung's K8Fxxxx, K8Cxxxx, K8Sxxxx, K8Pxxxx series, from 256Kbit to 1Gbit, with 8/16
bit data width, full support for LV series
•
NAND FLASH: Samsung K9xxx, Hynix HY27xxx, Toshiba TC58xxx, Micron MT29Fxxx,
Spansion S30Mxxx, Numonyx (ex STM) NANDxxx
•
LBA-NAND: Toshiba THGVNxxx
•
mDOC H3: SanDisk (ex M-Systems) SDED5xxx, SDED7xxx, MD2533xxx, MD2534xxx,
Hynix HY23xxx
•
Multi-chip devices: NAND+RAM, NOR+RAM, NOR+NOR+RAM, NAND+NOR+RAM
•
FRAM: Ramtron
•
MRAM: Everspin MRxxxxx8x
•
NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK STKxxx, XICOR 2xxx, ZMD U63x
series
•
Serial E(E)PROM: Serial E(E)PROM: 11LCxxx, 24Cxxx, 24Fxxx, 25Cxxx, 59Cxxx, 85xxx,
93Cxxx, NVM3060, MDAxxx series, full support for LV series, AT88SCxxx
•
Serial Flash: standard SPI (25Pxxx, 25Fxxx, 25Lxxx, 25Bxxx, 25Txxx,25Sxxx, 25Vxxx,
25Uxxx, 25Wxxx, 45PExx), high performance Dual I/O SPI (25Dxxx, 25PXxxx), high
performance Quad SPI (25Qxxx, 26Vxxx), DataFlash (AT45Dxxx, AT26Dxxx)
•
Configuration (EE)PROM: XCFxxx, XC17xxxx, XC18Vxxx, EPCxxx, EPCSxxx, AT17xxx,
AT18Fxxx, 37LVxx
•
1-Wire E(E)PROM: DS1xxx, DS2xxx
•
PLD Altera: MAX 3000A, MAX 7000A, MAX 7000B, MAX 7000S, MAX7000AE, MAX II/G/Z
•
PLD Lattice: ispGAL22V10x, ispLSI1xxx, ispLSI1xxxEA, ispLSI2xxx, ispLSI2xxxA,
ispLSI2xxxE, ispLSI2xxxV, ispLSI2xxxVE, ispLSI2xxxVL, LC4xxxB/C/V/ZC/ZE, M4-xx/xx,
M4A3-xx/xx, M4A5-xx/xx, M4LV-xx/xx, ispCLOCK, Power Manager/II, ProcessorPM
•
PLD: Xilinx: XC9500, XC9500XL, XC9500XV, CoolRunner XPLA3, CoolRunner-II
•
other PLD: SPLD/CPLD series: AMD, AMI, Atmel, Cypress, Gould, ICT, Lattice, National
Semicond., Philips, STMicroelectronics, TI (TMS), Vantis, VLSI
•
FPGA: Actel: ProASIC3, IGLOO, Fusion
•
FPGA: Lattice: MachXO, LatticeXP, ispXPGA
•
FPGA: Xilinx: Spartan-3AN
•
Clocks: TI(TMS), Cypress
•
Special chips: Atmel Tire Pressure Monitoring ATA6285N, ATA6286N, PWM controllers:
Zilker Labs, Analog Devices, Gamma buffers: TI, Maxim ...
40
Summary of Contents for SEEprog
