Elnec s. r. o.
26
ESD protection on each pin of ISP connector (IEC1000-4-2: 15kV air, 8kV contact)
Only for ISP device: two output signals, which indicate state of work result = LED OK and
LED Error (active level: min 1.8V)
input signal, switch YES! equivalent (active level L: max 0.8V)
DEVICE SUPPORT
Programmer, in ZIF socket
NAND FLASH: Samsung K9xxx, KFxxx, SK Hynix (ex Hynix) HY27xxx, H27xxx, Toshiba
TC58xxx, TH58xxx, Micron MT29Fxxx, (ex Numonyx ex STM) NANDxxx, Spansion
S30Mxxx, S34xxx, 3D-Plus 3DFNxxx, ATO Solution AFNDxxx, Fidelix FMNDxxx, Eon
Silicon Sol. EN27xxx, ESMT F59xxx, LBA-NAND Toshiba THGVNxxx, Macronix MX30xxx,
MX60xxx, Winbond W29Nxxx
serial NAND FLASH: Micron MT29Fxxx, GigaDevice GD5Fxxx, Winbond W25Nxxx, ESMT
F50xxx, ATO Solution ATO25xxx, All-Flash AFAxxx, AFSxxx, Macronix MX35xxx
eMMC: Hynix H26Mxxxxxxxx, Kingston KE44B-xxxx/xxx, Micron MTFCxxxxxx, Numonyx
NANDxxxxxxxx, Phison PSM4A11-xx, Samsung KLMxxxxxxx, SanDisk SDINxxx-xx, Toshiba
THGBMxxxxxxxxxx
eMCP: eMMC+RAM
Memory Cards: MMC, SD, SDHC, SDXC
Multi-chip devices: NAND+RAM, NOR+RAM, NOR+NOR+RAM, NAND+NOR+RAM
Serial Flash: standard SPI, high performance Dual I/O SPI and Quad I/O SPI (25Bxxx,
25Dxxx, 25Exxx, 25Fxxx, 25Lxxx, 25Mxxx, 25Pxxx, 25Qxxx, 25Sxxx, 25Txxx, 25Uxxx,
25Vxxx, 25Wxxx, 25Xxxx, 26Vxxx, 45PExx, MX66Lxxx, S70FLxxx), DataFlash (AT45Dxxx,
AT26Dxxx)
parallel NOR Flash: 28Fxxx, 29Cxxx, 29Fxxx, 29GLxxx, 29BVxxx, 29LVxxx, 29Wxxx,
49Fxxx series, Samsung's K8Fxxxx, K8Cxxxx, K8Sxxxx, K8Pxxxx series, ...
EPROM: NMOS/CMOS, 27xxx and 27Cxxx series
EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series, 3D Plus 3DEExxxxxxxx
mDOC H3: SanDisk (ex M-Systems) SDED5xxx, SDED7xxx, MD2533xxx, MD2534xxx,
Hynix HY23xxx
FRAM: Ramtron
MRAM: Everspin MRxxxxx8x, 3D Plus 3DMRxxxxxxxx
NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK STKxxx, XICOR 2xxx, ZMD U63x
series
Serial E(E)PROM: 11LCxxx, 24Cxxx, 24Fxxx, 25Cxxx, 30TSExxx, 34Cxxx, 34TSxx, 59Cxxx,
85xxx, 93Cxxx, NVM3060, MDAxxx series, full support for LV series, AT88SCxxx
Serial FRAM: Cypress(Ramtron): FM24xxxxxx, FM25xxxxxx, Fujitsu: MB85RCxxxx,
MB85RSxxxx, Lapis(OKI, Rohm): MR44xxxxx, MR45xxxxx
Serial MRAM: Everspin MH20xxx, MH25xxx
Configuration (EE)PROM: XCFxxx, XC17xxxx, XC18Vxxx, EPCxxx, EPCSxxx, AT17xxx,
AT18Fxxx, 37LVxx
1-Wire E(E)PROM: DS1xxx, DS2xxx
PLD Altera: MAX 3000A, MAX 7000A, MAX 7000B, MAX 7000S, MAX7000AE, MAX II/G/Z,
MAX V
PLD Lattice: ispGAL22V10x, ispLSI1xxx, ispLSI1xxxEA, ispLSI2xxx, ispLSI2xxxA,
ispLSI2xxxE, ispLSI2xxxV, ispLSI2xxxVE, ispLSI2xxxVL, LC4xxxB/C/V/ZC/ZE, M4-xx/xx,
M4A3-xx/xx, M4A5-xx/xx, M4LV-xx/xx, ispCLOCK, Power Manager/II, ProcessorPM
PLD: Xilinx: XC9500, XC9500XL, XC9500XV, CoolRunner XPLA3, CoolRunner-II
Summary of Contents for BeeHive204
