Elnec BeeHive204, User Manual

Page: 170 / 179

Elnec s. r. o.
170
Command line parameters PG4UWMC
Program PG4UWMC supports following command line parameters:
/prj:<file_name>
Loads project file. Parameter <file_name> means full or relative project file path and name.
There is also available to make Load project operation from command line by entering project
file name without prefix /prj...
Example:
pg4uwmc.exe c:\projects\myproject.eprj
Makes load project file "c:\projects\myproject.eprj".
/autoconnectsites
The command forces PG4UWMC to connect programmer Sites (start control program PG4UW
for each Site) during start of PG4UWMC, for all Site-s that were used, when PG4UWMC was
recently closed. There is also equivalent option "Auto-connect Sites" available in "Settings"
dialog of PG4UWMC.
Hardware
Due a large variety of parallel port types, a case may occur when the programmer cannot "get
concerted" with the PC. This problem may be shown as none communication between the PC
and the programmer, or by unreliable communication. If this behavior occurs, try to connect
your programmer to some other PCs or other parallel ports near you.
If you find none solution, please document the situation, i.e., provide us an accurate
description of your PC configuration, including some other circumstances bearing on the
problem in question, and advise the manufacturer of your problem. Don’t forget please enter of
PC type, manufacturer, speed, operation system, resident programs; your parallel port I/O
manufacturer and type. Use please
Device problem report form for this purpose.
Warning:
Class A ITE notice
Devices described at this manual are class A products. In domestic
environment this products may cause radio interference in which case the
user may be required to take adequate measures.
Because BeeHive204, BeeProg2 and BeeProg2C have internal power supply, follow these
special precautions:
Circuit breakers (overcurrent protection) must be a part of building electrical installation.
Pull out power cord plug from outlet to disconnect programmer from mains. The outlet must
be placed near to programmer and must be easy accessible.