Elnec BeeHive204, User Manual

Page: 158 / 179

Elnec s. r. o.
158
Timer refresh rate defines how often the PG4UWMC program will request status information
from running Programmer Sites. Status information means current device operation type,
progress, result and so on. Current status information is displayed in main window of
PG4UWMC. The default timer refresh rate value is 200ms. If you wish faster refresh of status
information displayed in Operation panel of PG4UWMC, select shorter refresh interval. If you
notice the system performance slow down, when using faster refresh, select higher refresh
value to make refresh less often. On the Pentium 4 computers there is almost no performance
penalty depending on timer refresh rate but on slower computers it is sometimes useful to
select longer (less often) timer interval.
Programmer internal storage (buffer) Please take a look at General options/Buffer, at radio
group Erase buffer(s) in programmer before power-off part help page.
Options / Statistics & Count down
This command shows Statistics & Count down settings.
Statistics gives the information about actual count of device operations, which were
proceeded on selected type device. If one device is corresponding to one device operation,
e.g. programming, the number of device operations will be equal to number of programmed
devices.
The next function of statistics is Count down . Count down allows checking the number of
device operations, and then number of devices, on which device operations have to be done.
After each successful device operation the value of count down counter is decremented. Count
down has user defined start number of devices to do. When count down value reach zero, it
means, specified number of devices is complete and user message about complete count
down will be displayed.
Statistics & Count down contains following options:
Check boxes Program , Verify , Blank , Erase and Read define operations, after which
statistics values increment.
Any selected and performed device operation will increment the Total counter and one of
Success or Failure counters depending on device operation result (success or failure).