Gold Bell Installation Guide
MAN-G-BELIG (Ver. 1.200)
|Connector J2 |
www.elmomc.com
14
Table of Contents
Chapter 6:
Mounting the Gold Bell
The Gold Bell was designed for mounting on a printed circuit board (PCB) via 1.27 mm pitch 0.41
mm square pins and 2 mm pitch 0.51 mm square pins. When integrating the Gold Bell into a device,
be sure to leave about 1 cm (0.4") outward from the heat sink to enable free air convection around
the drive. We recommend that the Gold Bell be soldered directly to the board. Alternatively, though
this is not recommended, the Gold Bell can be attached to socket connectors mounted on the PCB.
If the PCB is enclosed in a metal chassis, we recommend that the Gold Bell be screw-mounted to it
as well to help with heat dissipation. The Gold Bell has screw-mount holes on each corner of the
heat sink for this purpose – see below.
All measurements are in mm.
Figure 1: Gold Bell Dimensions
