Eliet GZC 1000, Manual

Page: 35 / 92

35
HANDGREEP
STARTKOORD
Trekrichting
English
• Operate the starter. Tug a bit on the starter handle
until you feel resistance, and then pull briskly and
firmly in the direction of the arrow shown here.
Allow the starter chord to recoil back. Repeat this
until the motor is running on its own.
Warning :
Do not let the starter handle slam up against the motor. Allow the starter chord
to recoil slowly so as to prevent causing damage to the starter.
• Several idle efforts to start the engine may point to a wet spark plug. In that case the spark
plug must be cleaned or replaced (see § 11.3.5 Check or replace spark plugs).
• Once the engine is running, push back the handle; the CHOKE will open again. This prevents
the engine from getting too much fuel. If the choke is not reopened, the engine will slow down
and start to smoke heavily, and eventually come to a stop. Restart the engine without opening
the CHOKE if this happens.
Warning:
The machine becomes a source of danger when the engine is running. A wrong
action can put the machine in motion. In a situation that could lead to loss of
control over the operation the engine must be switched off immediately.
Ways to quickly stop the machine:
• Release the All-in-one
TM
lever; all drives will be disengaged immediately.
• By turning the general on/off switch to the OFF position, the motor will stop running and, of
course, there will be no more driving force.