Eliet GZC 1000, Manual

Page: 33 / 92

33
English
• Never refuel at the location where the machine is later to be operated Keep a distance of at
least 10 m from the selected work area Doing so will avoid creating a fire hazard.
• The fuel tank sits on top of the motor and has a total capacity of
• Clean off the area around the cap of the fuel tank and remove it.
• Take note that a fuel filter can be inserted into the opening of the tank. Refrain from pouring
too quickly; allow the petrol sufficient time to penetrate the filter without overflowing.
• If the tank does not contain a sieve, use a hopper with a filter to keep unwanted rubbish from
getting into the tank.
• Do not fill the tank completely. Fill up to approximately 10 millimetres from the brim. So never
fill it up to the brim.
• Considering petrol’s flammability, keep in mind that the hot exhaust is right next to the tank.
• Put the cap back on the tank as quickly as possible. If any petrol is spilled whilst refilling, then
the motor should be immediately cleaned.
• Also be aware that clothing does not come in contact with the petrol. If this happens, the
clothing should be immediately changed.
• It is irresponsible and, thus, strictly forbidden to refill the tank in the vicinity of smokers or
near an open fire.
• If fuel is swallowed or comes in contact with the eyes, consult a doctor immediately.
9.5 Starting the petrol engine
For your information:
Please also read your engine manual for more information. The ‘General’ chapter
in the manual identifies the key engine functions in § 6.
The paragraph below describes the procedure to start a Honda GX270 (GZC 1000). The procedure
for starting the B&S Vanguard 6.5 HP (GZC750) is similar.
Caution:
Never start the machine when dust has settled on the engine or between its
cooling fins. It reduces proper cooling of the engine and can cause a fire. Fur-
thermore, sand and ground dust can block the motion of any external machine
parts.
If this has not been done when going through the checklist, the engine must be checked for
adequate oil (read § 11.3.2 Checking the engine’s oil level)and fuel levels (read § 9.4 Refuelling)
before starting it.