Elettronica Santerno SINUS/ISD 200 S-0.75, User Manual, Page: 48 / 206

15P0082B8
USER MANUAL
SINUS/ISD
5 - 6/14
5.4.2 CHANGING A PARAMETER VALUE
Refer back to “ The Programmer Menu System Map” to see how the menu is
mapped.
Each menu contains parameters.
With the Parameter you want on view, press M M to begin editing.
The up (
∆∆
) and down (
∇ ∇
) keys will now change the parameter/function value.
Press E E to finish editing.
The four keys will once again navigate around the Menus . Refer back to
“Navigating the Menu System”, page 5-4/14.
5.4.3 WHAT DO THE SYMBOLS MEAN NEXT TO SOME
PARAMETERS?
5.4.3.1 Parameter Status Information
→ ←
=
→ →
Pressing M M in a parameter displays
→ →
on the left of the bottom line to indicate
that the up and down keys will now change parameter values. Pressing E E
removes the symbol and reverts the up and down keys to scrolling through the
parameters.
← ←
A writable parameter may be non-writable if it is the destination of a link. In this
case it will be indicated by
← ←
appearing on the left of the bottom line.
= =
Non-writable parameters are identified by
= =
appearing on the left of the bottom
line.
Note that some parameters become non-writable when the Inverter is running.
5.4.3.2 Expanded Menu Information >>
The parameters listed below are followed by >> >> to the right of the bottom display line indicating that there is more
information. Press the M M key to display a further list of parameters.
AUTO RESTART menu at level 4: AR TRIGGERS 1, AR T 1, AR TRIGGERS 2
AR T 2
TRIPS STATUS menu at level 4 : DISABLED TRIPS, DISABLED TRIPS+,
ACTIVE TRIPS, ACTIVE TRIPS+,
TRIP WARNINGS, TRIP W
OP STATION menu at level 4: ENABLED KEYS
increment
decrement
menu
change
exit
menu
change
EDITING PARAMETERS
E M