Elettronica Santerno SINUS/ISD 200 S-0.75, User Manual, Page: 150 / 206

15P0082B8
USER MANUAL
SINUS/ISD
9 - 6/6
9.3 9.3 COMMUNICATIONS STATUS COMMUNICATIONS STATUS
The COMMS STATUS parameter (Tag 272) in the COMMS CONTROL function block monitors the sequencing
of the Inverter. It is a 16-bit word based on standard fieldbus drive profiles. Some bits are not implemented in the
initial release and are set to 0 (see “Supported” column of the table below).
Bit Bit Name Name Description Description Supported Supported
0 Ready To Switch On
√√
1 Switched On Ready for operation (refer control bit 0)
√√
2 Operation Enabled (refer control bit 3)
√√
3 Fault Tripped
√√
4 (Not) Voltage Disabled OFF 2 Command pending
√√
5 (Not) Quick Stop OFF 3 Command pending
√√
6 Switch On Disable Switch On Inhibited
√√
7 Warning
8 SP / PV in Range
9 Remote = 1 if Drive will accept Command Word
√√
10 Setpoint Reached
11 Internal Limit Active
12
13
14
15
Ready To Switch On
Same as the SWITCH ON ENABLE output parameter of the SEQUENCING LOGIC function block.
Switched On
Same as the SWITCHED ON output parameter of the SEQUENCING LOGIC function block.
Operation Enabled
Same as the READY output parameter of the SEQUENCING LOGIC function block.
Fault
Same as the TRIPPED output parameter of the SEQUENCING LOGIC function block.
(Not) Voltage Disabled
If in REMOTE COMMS mode, this is the same as Bit 1 of the COMMS COMMAND parameter. Otherwise it is
the same as the /COAST STOP input parameter of the SEQUENCING LOGIC function block.
(Not) Quick Stop
If in REMOTE COMMS mode, this is the same as Bit 2 of the COMMS COMMAND parameter. Otherwise it is
the same as the /FAST STOP input parameter of the SEQUENCING LOGIC function block.
Switch On Disable
Set (=1) only when in START DISABLED state.
Remote
This bit is set (= 1) if the Inverter is in Remote mode AND AND the parameter REMOTE COMMS SEL of the COMMS
CONTROL function block is Set (= 1).