Elettronica Santerno SINUS/ISD 200 S-0.75, User Manual, Page: 10 / 206

15P0082B8
USER MANUAL
SINUS/ISD
1 - 2/2
1.3 1.3 ABOUT THIS MANUAL ABOUT THIS MANUAL
This manual is intended for use by the installer, user and programmer of the SINUS/ISD inverter. It assumes a
reasonable level of understanding in these three disciplines.
Note: Please read all Safety Information before proceeding with the installation and operation of this unit.
There is a column for you to record your application’s parameter settings in the table in Chapter 10. It is
important that you pass this manual on to any new user of this unit.
1.3.1 INITIAL STEPS
Use the manual to help you plan the following:
Installation Installation
Know your requirements:
•
certification requirements, CE conformance
•
conformance with local installation requirements
•
supply and cabling requirements
Operation Operation
Know your operator:
•
how is it to be operated, local and/or remote?
•
what level of user is going to operate the unit?
•
decide on the best menu level for the Operator Station (where supplied)
Programming (Operator Station or suitable PC programming tool only) Programming (Operator Station or suitable PC programming tool only)
Know your application:
•
install the most appropriate macro
•
plan your “block diagram programming”
•
enter a password to guard against illicit or accidental changes
•
learn how to back-up your application data
•
customise the Operator Station to the application
1.3.2 HOW THE MANUAL IS ORGANISED
The manual is divided into chapters and paragraphs. Page numbering restarts with every chapter, i.e. 1 - 2/2 is
Chapter 1, page 2 of 2 pages.
1.3.2.1 Application Block Diagrams
You will find these at the rear of the manual. The pages unfold to show a complete block diagram, these will
become your programming tool as you become more familiar with the SINUS/ISD ’s software.
1.3.2.2 Information for Users without an Operator Station
This symbol identifies important text for users operating the Inverter using the default (factory) set-
up.
If the text is italic, such as this , then the information is especially for users without the Operator
Station or suitable PC programming tool.
DEFAULT