Elettronica Santerno SINUS/ISD 200 S-0.75, User Manual, Page: 151 / 206

SINUS/ISD 15P0082B8
USER MANUAL
10-1/16
10. 10. 0 P 0 P
ARAMETER ARAMETER
S S
PECIFICATION PECIFICATION
T T
ABLE ABLE
The headings for the Tag No. table are described below.
Tag Tag A numeric identification of the parameter. It is used to identify the source
and destinations of internal links.
Name Name The parameter name as it appears on the MMI.
Block Block The menu page and function block under which the parameter is stored.
Type Type INT (Signal) fixed point value – 16BITS
USINT (Signal) fixed point value – 8BITS
BOOL A Boolean (bit) representing FALSE or TRUE
ENUM An enumerated value representing a selection
STRING An ASCII string
TAG A value representing a choice of TAG
D_TAG A value representing a choice of Destination tag as an internal
link
S_TAG A value representing a choice of Source tag as an internal link
WORD 16 Bit hexadecimal number
Range Range This varies with parameter type:
INT The upper and lower limits of the parameter, indicating the
parameter’s true, internally-held, number of decimal (a reduced
number of digits may be shown by the Operator Station).
USINT As INT above
BOOL 0 = FALSE, 1 = TRUE
ENUM A list of possible selections for that parameter
STRING Specified number of characters
TAG The tag number of any parameter
D_TAG The tag number of an input parameter
S_TAG The tag number of an input or output parameter
(May be set to a negative value indicating a feedback link)
WORD 0000 to FFFF (hexadecimal)
ID ID Serial Communications Mnemonic:
Refer to Chapter 14: “Serial Communications”
Notes Notes You can record your application’s settings here.
Output parameters are not saved in non-volatile memory.
1. This input parameter is not saved in non-volatile memory.
2. This parameter is automatically saved in non-volatile memory.
3. This parameter forms part of the motor configuration.
4. This parameter is not adjustable from the operator station.
5. This parameter cannot be the destination of a link.
6. This parameter cannot be the source of a link.
7. This parameter can only be written to when the Inverter is stopped.
8. This parameter can only be written to when the Inverter is in
configuration
mode.
9. This parameter is not writable from serial comms.