28
(3) Time Configuration in hours and minutes. Starting the selection the configuration is
Pushing the button
and
it is possible to visualize the actual time and date and modify them,
first the hours then the minutes. The hour change will occur only exiting the programming mode.
The hour change will influence the data storage thus it is important to operate modifications only if
strictly necessary, otherwise leave to the instrument management software the clock update.. If
you maintain the configuration
the clock will not be modified. Should modifications be
edited and clock changes be avoided, it is necessary to set the display to
which is
located after the last valid hour or minute (i.e. beyond 11 pm or under 12 am).
(4) Identifies the standard time.
while
identifies the daylight saving or
summer time.
(5) Identifies the clock set up page.
In the second page of clock set up it is possible to program the calendar.
(6) It identifies the time programming page N° 2.
(7) Area of calendar setting and starting from left: year, month, day
. Even for the date
it is possible to avoid the modification saving, switching to the initial position
which does not save modifications.
5.1.2.7.1 Clock set up with Modbus registers.
To set up the calendar clock the Modbus Holding Registers from 140 to 165 have to be used.
Refer to chapter 9 for the details.
