41
•
Construction standards:
(LVD) IEC 1010-1, IEC 1010-2-032 600V CAT III, pollution degree 2
(EMC) EN50081-1 class B EN50082-2
•
Overload protection:
Max. 1200 A for 40'
•
Output impedance:
1
Ω
.
8.9
ON BOARD MEMORY SPECIFICATIONS
•
Size:
1 Megabyte (7840 records in Standard LOG, 677 records in Sample LOG)
•
Type:
Non-volatile serial flash-memory
•
Number of writings:
10.000 write-cycles min.
9
OPERATION AND MAINTENANCE OF INSTRUMENT
9.1
CAUTION AND HINTS
Always remember the following points in order to get the best from your instrument:
−
The instrument is designed to operate under mains power. It should be used on the power of the internal
rechargeable Ni-Cd battery only for short intervals.
−
The battery recharges automatically when the instrument is connected to the mains.
−
The I/O switch does not disconnet the instrument from the mains, but merely switches off the instrument's low
voltage circuits.
−
The backlight should be switched off when the instrument is running off the battery. The backlight can be turned on
temporarily by means of a button on the rear panel.
−
Regularly check for the amount of paper left and for printer cartridge wear. Do not allow the printer to operate
without paper as this causes rapid wear.
−
If the printer does not work, an internal fuse may have blown. Refer the instrument to an authorised assistance
centre.
