Eizo SCD 19102, Instruction Manual

Page: 57 / 104

Commissioning
7.4 Make settings
SCD 19102 / SMD 19102
Instruction Manual, 05/2008, A5E01588521A-002
57
7.4.1 Screen saver
Image sticking
Image sticking is an effect in which a faint image of the previous screen contents can be
seen after the display contents have changed. By using a screen saver with permanently
changing screen contents, unnecessary effects of the same image are avoided.
●
A screen saver function should be used in order to reduce "image sticking" that may
occur with LCD displays.
Image sticking occurs despite use of a screen saver function
If image sticking occurs despite use of a screen saver function, this can be rectified or
reduced by leaving the display switched on for a longer period with a black image.
7.4.2 Adjusting the image geometry
The display automatically recognizes the applied standard, and set-up values for each
standard are preprogrammed. However, depending on the graphics card used, it may still be
necessary to align and size the picture for the selected standard.
7.4.3 Adjusting the brightness and contrast
The brightness and contrast must be adjusted for the respective graphics card (different
output levels) in the system on site.
CAUTION
Brightness and contrast can only be set accurately using a photometer (Serial Spot Meter,
Serial Luminance Meter, Universal Serial Luminance Meter, Advanced Serial Luminance
Meter).
CAUTION
Fine adjustment of analog inputs: only via 15-pin Sub-D and DVI-I sockets
Fine adjustment of digital input: not necessary
•
Fine adjustment of the Flat Panel Display should only be carried out via the two analog
ports (15-pin Sub-D and DVI-I).
• The digital input (DVI-D) does not require a fine adjustment since the signal display is
always optimum. With a fine adjustment, it is possible that gray scales are not displayed.