EFI E-45, Installation And Service Manual, Page: 85 / 126

85 Installation and Service Guide
Replacing parts
To reassemble the E-45 and verify functionality
1
Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables inside the E-45, make sure that:
• Covers are securely installed after routing cables
• Cable routing does not interfere with the operation of internal components nor interfere with removing or replacing
components
• Cables are not tangled nor looped around internal circuit boards or components (such as capacitors and resistors)
• Cables do not lie on or against any internal heating element
• Cables do not interfere with opening or closing E-45 panels
•
Cable slack is secured with a tie-wrap
2
Restore the E-45 to the upright position.
3
Replace any panels that you removed earlier, as described on page 50 .
4
If you replaced the motherboard, make sure that the new motherboard solves the problem that you are troubleshooting,
and then transfer options to the new motherboard (see
page 67 ).
5
If the E-45 is to be mounted on the furniture with the monitor, see the reassembly instructions that is provided with the
furniture assembly (
page 122 ).
6
Connect the power cable to the E-45 (see page 18 ).
7
Connect the E-45 to the printer (see page 21 ).
8
Print the Test Page and Configuration page.
•
If pages do not print, verify that the interface cables are properly connected.
• If image quality is poor, test the printer (see the service documentation that accompanies the printer).
9
Connect to the network (see page 23 ).
10
Ask the site administrator to download a test job over the network.
If the job does not print, or has poor image quality, see printing problems and the Troubleshooting sections of the user
documentation.