65
Installation and Service Guide: Color Controller E-45
Replacing parts
2
Install the motherboard in the chassis.
Angle the motherboard so that the motherboard connectors fit into the cutouts in the back of the chassis.
3
Align the mounting holes on the motherboard with the standoffs located in the base of the chassis.
4
Secure the motherboard to the chassis using all the mounting screws that you removed earlier.
Partially tighten each screw before completing tightening any one screw. Do not overtighten the screws; doing so could
damage traces on the motherboard.
You are now ready to complete motherboard installation.
To replace boards, cables, and components
1
Replace the hard disk drive bracket, with hard disk drive attached (see
You removed the hard disk drive bracket to provide clearance for removing the motherboard.
2
Replace the following cables (see
for the connector locations).
•
CPU fan cable
•
24-pin motherboard power cable
•
8-pin motherboard power cable
•
Fiery QuickTouch power/LED cable
•
Hard disk drive cable
•
DVD drive cables:
•
Power and data combination cable
•
SATA data cable
•
Fiery QuickTouch USB port cables
•
Rear fan cable
•
In-line spectrophotometer
3
Secure cables as necessary with any plastic cable clamp that you may have removed earlier.
Important:
Make sure that the flexible grounding tabs on the cutouts for the network ports make contact with the
outside of the ports. Do not allow the tabs to fold over or become bent inside the ports. The ports will not function
if the tabs are placed improperly. Take care when lowering the new motherboard into the chassis. Do not strike the
motherboard against the metal standoffs attached to the chassis, as doing so can damage the components on the
underside of the motherboard.