EFI E-45, Installation And Service Manual, Page: 31 / 126

31 Installation and Service Guide: Color Controller E-45
Using the E-45
To access Configure from Command WorkStation
1
In Command WorkStation, as Administrator, do one of the following:
• In the
Server
menu, click
Configure
.
•
From the
SERVERS
list, right-click the E-45 and select
Configure
.
• In
Device Center
, on the
General
, click
Configure
button in lower right corner.
2
If the
Fiery Setup
dialog box displays, click
Configure
.
If you have not completed initial setup, you may want to click
Fiery Setup Wizard
instead. For more information, see
Configuration and Setup .
If you use the Fiery Setup Wizard (from Command WorkStation or WebTools) and click
Finish
at the end of the wizard,
the
Fiery Setup
dialog box does not display again in any location.
Using the E-45 on Fiery QuickTouch
The Fiery QuickTouch on the front of the E-45 allows you to do the following:
•
View print job status and alerts
• Use Fiery System Restore to back up and restore the E-45
• Replace the motherboard (when the motherboard replacement dongle is inserted into a USB port)
• View the IP address of the E-45
•
Shut down, restart, or reboot the E-45 (see page 41 ).
Note:
You can also shut down and restart the E-45 through the printer touch panel (see page 36 ).
•
Interact with the E-45 during software installation and initial setup (see page 97 )
• Run certain diagnostics (for service purposes only)