Servicing the E-45 with furniture
This chapter describes how to remove the E-45 from the furniture in order to access internal components for service.
For the assembly instruction on the Fiery NX Station, see the documentation provided with the Fiery NX Station kit.
Procedures
If the E-45 is installed in the optional furniture, you must remove it from the furniture before performing most service
procedures.
Figure 37:
E-45 installed on the furniture
Removing the E-45 from the furniture
1
Make sure the E-45 is powered off and all the cables are removed from the back of the E-45.
2
Open the back door of the NX Station and remove all the cables from the connector panel of the E-45.
3
Pull the server tray of the NX Station out of the stand.
Replacing the E-45 in the furniture
1
Make sure that all the chassis panels are attached.
2
Lift the E-45 and place it on the server tray.
3
Slide the tray into the stand.
4
Reconnect all the cables.