23
Installation and Service Guide: Color Controller E-45
Installing Hardware
Figure 6:
Printer and E-45 cable connection
To connect to the network
1
Make sure that the E-45 is powered off.
2
Make sure that the network cable is connected to the customer site network.
3
Connect the network cable to the upper RJ-45 network port on the back of the E-45.
The E-45 provides twisted pair connectivity to an Ethernet network. When the network cable is connected, the Ethernet
interface automatically detects the speed of the network environment. Depending on your network speed, the following
unshielded twisted pair (UTP) network cables are supported:
•
10BaseT: Category 3 or higher
•
100BaseTX: Category 5 or higher (4-pair/8-wire, short-length)
•
1000BaseT: Category 5e or higher (4-pair/8-wire, short-length)
A
printer connector panel
3
Printer interface (Data Transfer Unit) cable connection -
port B (Cyan, Black)
B
E-45
1
Crossover Ethernet cable connection
4
Power synchronization OFF/ON switch on the printer
interface board. Default position is OFF.
ON: Down
OFF: Up
2
Printer interface (Data Transfer Unit) cable connection -
port A (Yellow, Magenta)
1
2
3
4
A
B