Edwards iXM Series, Instruction Manual

Page: 23 / 104

Description
Units
Rating
▪ for 380 - 460 V a.c. systems
mA < 10
* Typical earth leakage values were measured at steady-state conditions.
Note that higher leakage currents can occur:
i) in transient conditions such as power on or pump acceleration
ii) with abnormal supply configurations such as a missing or earthed phase or
unbalanced supply voltages.
Contact us for more information about configuration requirements for earth leakage
reduction.
Table 9
Electrical connections
Description Mating connector description / external
supply rating
Internal supply rating
Mains connection
Refer to
Installation on page 25
for wiring diagram
Refer to Table: Pump electrical data for the
mains connector installed to each variant.
Insert type is one of:
Harting Han 40A, axial module, part num-
ber: 09 14 002 2701, 2.5 –
8 mm2 fine stran-
ded wire, Hood part number: 09 30 006
0442 or
Insert type is : Weidmüller 1789980000, 2.5
– 8 mm2 fine stranded wire, Hood part
number : 1652680000 (VDE 0295 class 5, re-
fer to Table: Wire assembly according to
VDE 0295 ), 8.9 mm maximum insulation di-
ameter or
Han K 4/4-F finger safe 09 38 008 2703, 6-16
mm
2
fine stranded wire (VDE 0295 class 5,
refer to Table: Wire assembly according to
VDE 0295 ), 8.9 mm maximum insulation di-
ameter
PDT interface (front) XLR type 5-way plug 24 V d.c. 0.2 A
System interface (rear) XLR type 5-way plug
24 V d.c. 0.75 A
*
Ethernet interface Standard RJ45 type or Neutrik® EtherCon®
RJ45
(IEEE802.3i 10 Base T
Ethernet)
USB flash memory stick/drive USB Type A flash stick only (no cable con-
nection allowed)
5 V d.c. 100 mA
EMS interface XLR type 6-way plug
External controlled stop button
Pin 1 supply, Pin 2 - return
Internal controlled stop button§
24 V d.c. 100 mA
10/2020 - ©Edwards Limited Page 20 M56635880_D
M56635880_D - Technical data