8-62
6205s2 BATHYMETRIC AND SIDE SCAN SONAR
0025262_REV_A
8.3.2
Two Sensors
Two sensors, such as a dual-headed GNSS (heading, position, and time source) and a motion reference
unit (roll, pitch, and heave), may be used to supply the necessary information. For this type of
configuration, only COM1 and COM2 will be used.
To configure the COM ports for the two sensors:
1.
Follow steps 1 through 6, as stated in the,
2.
Under [Serial3], set Create = 0, select File > Save and close the file, as shown in
CAUTION!
Do not touch anything else, or the system’s configuration
files could be seriously compromised, and functionality may suffer.
This will deactivate COM3. By deactivating this port, Sonar will report to Discover that only two
sensors are to be used on COM1 and COM 2 to parse the necessary sensor information. Therefore,
Discover will not throw up any errors if a sensor is not connected to COM3.
Figure 8-19: SonarSerial.ini File
3.
Reboot the Sonar Firmware by double-clicking on the Sonar icon in the main Sonar Remote
Desktop Screen, as shown in
FIGURE
8-15,
designated by green arrow.
Summary of Contents for 6205S2
