Edge-Core ECS3510-10PD, Management Manual

Page: 1254 / 1494

C
HAPTER
38
| Multicast Filtering Commands
MLD Filtering and Throttling
– 1254 –
◆
When the access mode is set to permit, MLD join reports are processed
when a multicast group falls within the controlled range. When the
access mode is set to deny, MLD join reports are only processed when a
multicast group is not in the controlled range.
E
XAMPLE
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#permit
Console(config-mld-profile)#
range
This command specifies multicast group addresses for a profile. Use the no
form to delete addresses from a profile.
S
YNTAX
[ no ] range low - ipv6-address [ high - ipv6-address ]
low-ipv6-address - A valid IPv6 address (X:X:X:X::X) of a multicast
group or start of a group range.
high-ipv6-address - A valid IPv6 address (X:X:X:X::X) for the end
of a multicast group range.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
MLD Profile Configuration
C
OMMAND
U
SAGE
Enter this command multiple times to specify more than one multicast
address or address range for a profile.
E
XAMPLE
Console(config-mld-profile)#range ff01::0101 ff01::0202
Console(config-mld-profile)#
ipv6 mld filter
(Interface Configuration)
This command assigns an MLD filtering profile to an interface on the
switch. Use the no form to remove a profile from an interface.
S
YNTAX
[ no ] ipv6 mld filter profile-number
profile-number - An MLD filter profile number.
(Range: 1-4294967295)