Edge-Core ECS3510-10PD, Management Manual

Page: 865 / 1494

C
HAPTER
23
| Authentication Commands
802.1X Port Authentication
– 865 –
◆
A port cannot be configured as a dot1x supplicant if it is a member of a
trunk or LACP is enabled on the port.
E
XAMPLE
Console(config)#interface ethernet 1/2
Console(config-if)#dot1x pae supplicant
Console(config-if)#
dot1x timeout
auth-period
This command sets the time that a supplicant port waits for a response
from the authenticator. Use the no form to restore the default setting.
S
YNTAX
dot1x timeout auth-period seconds
no dot1x timeout auth-period
seconds - The number of seconds. (Range: 1-65535)
D
EFAULT
30 seconds
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
This command sets the time that the supplicant waits for a response from
the authenticator for packets other than EAPOL-Start.
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout auth-period 60
Console(config-if)#
dot1x timeout
held-period
This command sets the time that a supplicant port waits before resending
its credentials to find a new an authenticator. Use the no form to reset the
default.
S
YNTAX
dot1x timeout held-period seconds
no dot1x timeout held-period
seconds - The number of seconds. (Range: 1-65535)
D
EFAULT
60 seconds