Edge-Core ECS3510-10PD, Management Manual

Page: 1290 / 1494

C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv6
– 1290 –
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
E
XAMPLE
Console(config)#mvr6 domain 1 upstream-source-ip 2001:DB8:2222:7223::72
Console(config)#
mvr6 vlan
This command specifies the VLAN through which MVR multicast data is
received. Use the no form of this command to restore the default MVR
VLAN.
S
YNTAX
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is
received. This is also the VLAN to which all source ports must be
assigned. (Range: 1-4094)
D
EFAULT
S
ETTING
VLAN 1
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
MVR source ports can be configured as members of the MVR VLAN using
the switchport allowed vlan command and switchport native vlan
command, but MVR receiver ports should not be statically configured as
members of this VLAN.
E
XAMPLE
The following example sets the MVR6 VLAN to VLAN 1:
Console(config)#mvr6 domain 1 vlan 1
Console(config)#