Edge-Core ECS3510-10PD, Management Manual

Page: 984 / 1494

C
HAPTER
26
| Interface Commands
Interface Configuration
– 984 –
10full - Supports 10 Mbps full-duplex operation
10half - Supports 10 Mbps half-duplex operation
flowcontrol - Supports flow control
D
EFAULT
S
ETTING
100BASE-FX: 100full (SFP)
100BASE-TX: 10half, 10full, 100half, 100full
1000BASE-T: 10half, 10full, 100half, 100full, 1000full
1000BASE-SX/LX/LH (SFP): 1000full
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
◆
The 1000BASE-T standard does not support forced mode. Auto-
negotiation should always be used to establish a connection over any
1000BASE-T port or trunk.
◆
When auto-negotiation is enabled with the negotiation command, the
switch will negotiate the best settings for a link based on the
capabilities command. When auto-negotiation is disabled, you must
manually specify the link attributes with the speed-duplex and
flowcontrol commands.
E
XAMPLE
The following example configures Ethernet port 5 capabilities to include
100half and 100full.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#
R
ELATED
C
OMMANDS
negotiation (987)
speed-duplex (989)
flowcontrol (986)
description
This command adds a description to an interface. Use the no form to
remove the description.
S
YNTAX
description string
no description
string - Comment or a description to help you remember what is
attached to this interface. (Range: 1-64 characters)