with regular signal transmissions for the
Control Panel to display the status
accordingly.
z
Before shipment, the battery is pre-installed
by the factory.
z
Power Saving Feature:
z
When idle, HA2000K is in “standby” mode
and uses no power. It will activate and
“wake-up” for 5 seconds when any key is
pressed.
z
After 5 seconds of key inactivity, the power
goes off and it returns to Stand-by mode.
z
Upon completion of a command input, the
power goes off and HA2000K returns to
Stand-by mode.
z
Test mode:
z
HA2000K can be put into Test mode by
entering the PIN code followed by “
”.
The Green Active LED goes on.
z
To exit Test mode, press “
” twice,
HA2000K will sound a long beep and the
Active LED will turn from Green to Orange,
then HA2000K returns to Standby mode.
Otherwise, HA2000K will automatically exit
Test mode after 5 minutes and return to
Standby mode.
<
<
N
N
O
O
T
T
E
E
>
>
PROBLEM?
20
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
)
Test Mode is helpful to bypass HA2000K
Tamper alarm when installing, replacing
low batteries or removing to different
mount site.
)
When entering Test mode, HA2000K will
sound a long beep with Active green
LED.
)
HA2000K will stay in Wake-up status
under Test Mode.
z
Tamper Protection:
z
HA2000K is protected against any attempt to
open the lid or to detach HA2000K from its
mounting surface.
z
Tamper protection is disabled when in Test
Mode.
z
Mounting KP-9:
z
Remove the 2 slide-out sections of front
cover.
z
Using the 2 mounting holes as a template,
mark off the hole positions in the most
appropriate place.
z
Insert the wall plugs if fixing into plaster or
brick surface.
z
Screw the HA2000K onto the wall plugs.
z
Replace the 2 slide-out sections.
z
Installation Procedures:
Step 1.
Put HA2000K in Test mode by entering
“0000” (default PIN code), then press
“
”. HA2000K will sound 1 long beep
and the green Active LED will turn on.
Step 2.
Adding HA2000K into the Control Panel:
Put the Control panel into “/-”
menu and select the “Add Devices” sub
menu.
Press “
” and “7” when requested.
HA2000K and Control Panel will beep.
Refer to the operation manual of your
control Panel under the section of
“/-” to complete the learn-in
process.
Step 3.
After the HA2000K is learnt-in, put the
Control Panel into “Walk Test” mode,
hold the HA2000K in the desired
location, press the “Test” and “7” button
to confirm this location is within signal
range of the Control Panel.
<
<
N
N
O
O
T
T
E
E
>
>
Please press “
” + “7” button if the
control panel doesn’t receive the signal
from HA2000K.
Step 4.
When you are satisfied that the HA2000K
works in the chosen location, you can
proceed with mounting the HA2000K
following the steps described above (see
Mounting HA2000K).
Step 5.
Setting the Pin Code:
Press “
“ and “6”, a long beep will be
sound.
Enter “0000” (default PIN code)
Press “
”, HA2000K sounds a long beep.
Enter your new 4-digit code
