PROBLEM?
6
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
C o n f i r m O n
C o n f i r m O f f
z
Add Siren
z
If there is any detector or Remote
Controller has been added already,
Step 1
. Put the Siren into learn mode (Refer to
Siren Operational Manual).
Step 2
. Move the cursor to the position
“Learn
Siren”
.
Step 3
. Press
“OK”
.
Step 4
. The Control Panel will then sound a long
beep and transmit Learning code to the
Bell Box. The Bell Box should respond
by activating its siren & strobe light
momentarily.
Step 5
. Place the Bell Box out of Learn mode.
Adding the siren is completed.
<
<
N
N
O
O
T
T
E
E
>
>
)
If the siren does not respond, make sure
that the Siren is in learn mode and repeat
the steps again.
)
After the Siren is added in, every time
pressing a PIN code & followed by
“OK”
key will result in the Control Panel
transmitting signal to the Bell Box. The
signal transmission is indicated by the
display running out of the screen and
back. During this period, key pressing is
prohibited.
)
Adding the Auto Dialer…etc. in the
system follows the same procedures as
adding in the Bell Box. Please refer to
each relative operation manual.
z
If there is no other detector or Remote
Controller being added first, the following
message will be displayed in Step 3.
P l e a s e a d d
o n e d e v i c e
The message will be displayed for 2 sec.
then the screen returns to
“/-“
menu. You are requested to add a
detector or Remote Controller first then
you can try programming Bell Box again.
z
Siren A/T On, Siren A/T Off
The Siren tamper switch can be enabled and
disabled remotely.
z
Disable the Siren tamper switch by
selecting
“Siren A/T Off”
and press
“OK”
.
z
Enable the Siren tamper switch by
selecting
“Siren A/T On”
and press
“OK”
.
<
<
N
N
O
O
T
T
E
E
>
>
)
The Siren tamper disable will
automatically revert to
“On”
after about
an hour if not switched back.
z
Confirm On, Confirm Off
The Siren can be enabled for arming and
disarming confirmation where beeps are
emitted from the Siren to validate that the
system has been armed and disarmed.
z
Disable the Siren Confirmation by
selecting
“Confirmation Off”
and press
“OK”.
z
Enable the Siren Confirmation by
selecting
“Confirmation On”
and press
“OK”
.
z
Delete Siren
To delete Siren, put the Control Panel into
the Program Siren menu. The Siren can be
removed by pressing 1 and 3 keys
simultaneously or by pressing 4 and 6 keys
simultaneously. A prompt message
“!!Remove BX!!”
will be displayed and a
long beep will sound to indicate that Siren
deletion is completed.
IV.
Walk
Test
This feature is available in the User and
Programming menus and operates in an identical
manner.
z
When
“Walk Test”
is selected, the following
message is displayed.
* W a l k
T e s t *
z
Pressing the test button on the sensor or any
