PROBLEM?
14
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
z
Enable the Control Panel Tamper protection
in the Programming mode under General
Setting’s menu after all the programming and
installations are completed.
II.
PIR
detector
HA2000P
After the PIR is learnt-in, put the Control Panel into
“Walk Test” mode, hold the PIR in the desired
location, and press the Test button to confirm this
location is within signal range of the Control Panel.
When you are satisfied that the PIR work in the chosen
location, you can proceed with installation.
z
Limitations
z
Do not position a PIR to look directly at a
door protected by a Door Contact, this could
cause the Door Contact and PIR radio signals
to be transmitted at the same instant when
entering, canceling each other out.
z
Do not install the PIR completely exposed to
direct sunlight.
z
Avoid installing the PIR in areas where
devices may cause rapid change of
temperature in the detection area, i.e. air
conditioner, heaters, etc.
z
Avoid large obstacles in the detection area.
z
Not pointing directly at sources of heat e.g.
Fires or boilers, and not above radiators.
z
Avoid moving objects in the detection area
i.e. curtain, wall hanging etc.
But It is recommended to install the PIR in the
following locations:
z
In a position such that an intruder would
normally move across the PIR’s field of view.
z
Between 2 and 2.5m above ground for best
performance.
z
In a corner to give the widest view.
z
Where its field of view will not be obstructed
e.g. by curtains, ornaments etc.
z
Mounting Method
z
The PIR is designed to be mounted on either
a flat surface or in a corner situation with
fixing screws and plugs provided.
z
The base has knockouts, where the plastic is
thinner, for mounting purpose. Four
knockouts are for surface fixing and four
knockouts are for corner fixing as shown in
the picture.
z
For corner mounting, at user’s own dicretion,
an optional triangular bracket is provided to
add Back Tamper Protection. Mount the
triangular bracket on he wall first with the
two pointing sticks on top facing you. Then,
you can just fit the PIR onto the hooks of the
triangular bracket or screw the PIR onto it.
z
Surface mounting:
Step1.
Remove the fixing screw and cover
assembly.
Step 2.
Break through the appropriate knockouts
on the base.
Step 3.
Using the holes as a template, drill holes
in the surface.
Step 4.
Insert the wall plugs if fixing it into plaster
or brick.
Step 5.
Screw the base into the wall plugs.
Step 6.
Screw the cover back onto its base.
z
Corner mounting:
Step 1.
Break through the two knockouts on the
triangular bracket.
Step 2.
Using the two holes as a template, drill
holes in the surface of the corner
Step 3.
Insert the wall plugs
Step 4.
Screw the triangular bracket into the wall
plugs with the two pointing sticks on top
facing you.
Step 5.
Fit the PIR onto the hooks of the
triangular bracket
Step 6.
If necessary, open the PIR by removing
the fixing screw and cover assembly
Step 7.
Break through the appropriate corner
fixing knockouts.
Step 8.
Using the corner fixing knockouts as a
template, drill holes in the surface in the
corner again
