button on the Remote Controller or triggering
the sensor, if the Control Panel received the
signal, it will sound a high volume door chime
and the display will show you which sensor
with its description is reacting.
P I R Z o n e 0 2 B
H A L L D O O R
PROBLEM?
7
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
z
The message will be displayed until replaced
by another test signal, with an
acknowledgement high volume chime.
z
The list of tested devices can be viewed by
scrolling up and down with the
“
S
”, “
T
”
keys.
z
Exit “Walk Test”
z
To exit “Walk Test” mode, press ”
“
key.
z
If no test signals are received for 10
minutes in the Programming mode, the
Control Panel will exit
“Walk Test”
mode
and power down automatically to
conserve battery power.
z
If no test signals are received for 3
minutes in the User menu, the Control
Panel will exit
“Walk Test”
mode and
power down automatically to conserve
battery power.
<
<
N
N
O
O
T
T
E
E
>
>
)
The outdoor Bell Box can be tested by
arming & disarming the system, the Bell
Box will respond as below:
z
While the Control Panel is armed, the
strobe light will beep once and will flash
the strobe after the Exit delay period has
expired.
z
While the Control Panel is disarmed, the
siren will give two short beeps and the
strobe will flash from side to side twice.
Operation
I.
User
Menu
1. Power Saving & Waking Up
The Control Panel is battery powered, to conserve the
battery power and to prolong the battery life, the
Control Panel is put in Power Saving mode in the
following two cases.
z
In normal operation mode, after 10
seconds of key inactivity.
z
In Programming mode, after 10 minutes
of key inactivity.
In Power Saving mode, the LCD display is blank and
the keypad backlight is also turned off.
To wake up the display:
z
Pressing any numeric key, the display
will show
“Enter Code, *_ _ _ “
with the
number key entered be treated as the
first digit of the PIN code and is masked
by the
“ * ”
sign.
z
Pressing any other key, the display will
show Alarm off ( or Home) status or a
“Enter Code _ _ _ _ ”
prompt message
is displayed to request you to enter
complete PIN code.
z
If there is any fault condition existing, any
key stroke is ignored but will result in the
fault message being displayed with a
two-tone fault sound being generated.
After the two-tone sound, normal key
pressing can be proceeded.
<
<
N
N
O
O
T
T
E
E
>
>
)
Further key strokes during the two-tone
sound period are ignored.
2. Entering User Menu
When the system is in Disarmed mode (Alarm off),
entering a valid user code can access the user menu,
the system can then be away armed or home armed via
this menu.
When the first numeric key is pressed, the display and
keypad light up with the following display:
E n t e r C o d e
* _ _ _
When the complete PIN code is keyed in followed by
“OK”
, within 10 sec., the first two lines of the user
menu is shown:
A w a y A r m
H o m e A r m
