ECOSAIRE EN Series, Owner'S Manual

Page: 70 / 142

Owners Manual Ecosaire
®
EN Series Precision Air Conditioner
Ecosaire ® July 2009 65
Data subject to change without notice.
Startup
Remote heat exchanger
installed properly?
(See HX manu-
al.)
Wire connections checked for
tightness?
(See Installation -
Wiring - Power .)
Pre-Startup check list complete?
(
See Startup - Pre-Startup
Checklists .)
Blower rotation on 3-phase units
correct?
(See Installation - Wiring
- Power .)
Airflow and blower speed adjust-
ed?
(See Installation - Air
Distribution - Adjust Airflow .)
Airflow . . . . . . . . . . . . . . .cfm
Refrigerant charge OK?
No alarms displayed?
Set points at design conditions?
Proper air distribution provided?
(See Installation - Air
Distribution .)
Vapor retardant installed prop-
erly?
(See Building - Moisture
Migration .)
Adequate service access pro-
vided?
(See Installation -
Unpacking & Locating .)
Unit level?
Main disconnect switch
installed?
(See Installation -
Wiring - Power .)
Optional fire alarm tested?
Water detectors tested?
Condensate drain connected,
P-trap installed, filled and
tested?
Condensate pump (if any)
operating?
Loss-of-airflow alarm tested?
Dirty filter alarm tested?
Humidifier jumpers correct?
Humidifier connectors tight?
All sensor readings true?
Date and time set?
All alarms cleared?
ECOSaire®
Startup Report & Warranty Registration
Warranty void unless this form is completed and a copy returned to factory within 2 weeks after start-up!
Installation Name..................................................................................................................................................................................
Installation Address ..............................................................................................................................................................................
Ecosaire
®
Representative.................................................................................................................................................................
Model # ......................................................................................................................Serial # ..............................................................
Compressor 1 (if any) Serial #...................................................................................Blower Belt Size................................................
Compressor 2 (if any) Serial #...................................................................................Software date . . . . . . . . . . . . . Rev. . . . . . . . .
Compressor 3 (if any) Serial #...................................................................................
Compressor 4 (if any) Serial #...................................................................................
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
your
initials
Blower volts (V)
L1-L2 L2-L3 L3-L1
NAMEPLATE
Remote HX (if any) volts (V)
Blower 1 amps (A)
Blower 3 (if any) amps (A)
Blower 2 (if any) amps (A)
Remote HX (if any) amps (A)
Humidifier amps (A)
Transformer 1 (smaller) output voltage ________
Transformer 2 (larger) output voltage ________
Heater Stage 1 amps (A)
L1
L2 L3
NAME
PLATE
Heater Stage 2 amps (A)
Heater Stage 3 amps (A)
Optional outdoor air-cooled heat exchanger location Above ECOS . . . . ft Below ECOS . . . . ft Same level as ECOS
Refrigerant connection size.....................Hot gas ...................Liquid Pipe length from
Ecosaire ®
to remote heat exchanger . . . . . . ft
ST
ARTUP