Eaton PXG 900, User Manual

Page: 49 / 75

PXG 900 User's Guide - Firmware Version 4.3 - 1/9/2017
47
Using Auto-Draw
When you enable Auto-Draw for one or two sources, Auto-Draw automatically connects all devices on their closest
source symbol. As you drag a device across the center of the screen, its connection line automatically snaps to the
other side. Each device has two parts that you can position: the device box and the connection symbol. If you drag
the device box, the symbol follows. However, if you drag the symbol, it moves independently from the device box.
If you double click a symbol, both it and the line connection points flip by 90 degrees. The exceptions are the vertical
and horizontal line symbols (which do not flip) and the Lettered Circle symbols (the letter doesn't flip but the
connection points do). When you click on a device in edit mode, the side bar changes to allow you to remove the
device. To go back to the configuration for the current one-line, click on any blank spot in the diagram.
Working with Symbols and Graphics
When you click one of the Additional Symbols in the sidebar, it appears in the upper left of the screen. From
there, drag it to the appropriate location.
Symbols and graphics flip just like the symbols on top of devices. Just double click them.
You can delete a symbol by clicking the "X" in the upper right corner of its selection box.
Click Save to save your changes so far without leaving edit mode. Click Edit to save and exit or cancel all
changes and return to viewing mode.
You can view a video detailing how to use the one-line tools by clicking this link: http://bcove.me/9cyfw
vxo