Eaton PXG 900, User Manual

Page: 19 / 75

PXG 900 User's Guide - Firmware Version 4.3 - 1/9/2017
17
1.
2.
3.
4.
Special Considerations for the AEM II
The gateway supports the AEM II with firmware at level 6 or greater. If your AEM II has a sub-network with devices
attached, you can add these devices
you've added the AEM II to the gateway. Once you have added an AEM II after
to the gateway, it is important to determine the version of the AEM II:
Go to the Network tab.
Click Edit.
Select the gear icon for Power Expert Gateway
Under Choose an action, select System Inventory.
The System Inventory shows the Firmware version for the AEM II device. The AEM II version must be 6 or higher.
For an AEM II Version 7 or higher only the following devices may be added to the sub-network: Digitrip T800,
Digitrip 810 and Digitrip 910. For an AEM II version 6, only the following devices may be added to the sub-network:
Digitrip T800, Digitrip 810 (AEM II V6) and Digitrip 910 (AEM II V6). If an incompatible device type is added to an
AEM II sub-network, the gateway will fail to properly communicate with the device and provide erroneous data.
Note: You can use these special version devices only as part of a AEM II sub-network and they will
appear as child devices of the AEM II. If you install these special devices without having them on an
AEM II sub-network, they either won't communicate at all or will provide erroneous information.
Special versions of devices for use as part of an AEM II sub-network.