IAC Installation Plan and Unpacking
2-3
EATON
Powerware
®
9390 IAC-B and IAC-T Installation and Operation Manual
S
164201590 Rev C
powerware.com
2.3 Inspecting and Unpacking the IAC
The cabinet is shipped bolted to a wooden pallet (see Figure 2-1) and protected with outer
protective packaging material.
C A U T I O N
쑺
The IAC is heavy (see Table A on page A-6). If unpacking instructions are not closely
followed, the cabinet may tip and cause serious injury.
쑺
Do not install a damaged cabinet. Report any damage to the carrier and contact your Eaton
service representative immediately.
쑺
Do not tilt the IAC more than 10° from vertical or the cabinet may tip over.
1.
Carefully inspect the outer packaging for evidence of damage during transit.
2.
Use a forklift or pallet jack to move the packaged cabinet to the installation site,
or as close as possible, before unpacking. Insert the forklift or pallet jack’s forks
between the pallet supports on the bottom of the unit.
NOTE
Verify that the forklift or pallet jack is rated to handle the weight of the cabinet
(see Table A on page A-6 for cabinet weight).
Figure 2-1. Powerware 9390 IAC as Shipped on Pallet
Summary of Contents for Powerware 9390 IAC-B
Page 145: ......
Page 146: ...164201590C 164201590 C...
