Eaton LMS, Installation Manual, Page: 86 / 202

L o c k i n g
C o m p a r t m e n t
Tools Required
-Phillips head screwdriver
-Plastic mallet
NOTE : Some assembly may require assistance.
REAR AND END PANEL INSTALLATION
1. Install the
Rear Panel by inserting the hooks on either
side of the panel into the Slotted Standards of the Full
Frame and pushing down. To assure that the hooks are
seated, tap the top corners with a plastic mallet or
equivalent. See
Figure 1 .
2. Position the
End Panels as shown in Figure 2 . Insert
the hooks on the End Panels into the Slotted Standards
and push down. Tap the top corners of the panels with
a plastic mallet to assure that the hooks are seated.
SHELF INSTALLATION
1. There are three factory installed screws along the top
and bottom edge of each Side Panel. These screws must
be backed out approximately 1/8”(3mm) as shown in
Figure 3 (inset).
2. After backing out all six lower screws, position the
Shelf
between the End Panels above the screws. Lower the
Shelf so that all six screws engage their corresponding
slots in the Shelf. Next, tighten the screws to secure the
Shelf. See
Figure 3 .
Locking Compartment
Figure 1
Rear panel
Hook
Slotted standard
Full frame
Figure 3
Figure 2
Full frame
Hooks
Slotted standard
End Panel
(R.H. shown)
Screws
80172
technical furniture
G-1
Screw
End Panel
Shelf
1/8”
End Panel
Shelf