Eaton LMS, Installation Manual, Page: 71 / 202

-1-
Tools Required
-Phillips head screwdriver
-Plastic mallet
-5/33” Allen wrench
1. Determine the location of the
Shelf End Panels .
Positon the end panels as shown. (The End Panels
are stamped “R.H.” and “L.H.”) Insert the hooks on
the End Panels into the slotted standards and push
down. To assure the hooks are seated, tap the top
rear corner of the panels with a plastic mallet or
equivalent. See
Figure 1 .
Make sure both End Panels are in the same location.
NOTE : If the shelf is being installed in the lowest
possible position, it is recommended that the
shelf be pre-assembed as shown above (upper
right), and then installed on the Full Frame
with two people. This allows the screws to
be pre-tightened.
2. The End Panels accept single or multiple levels of
steel shelves. Refer to shelf position diagrams on
next page.
Install the #10-24 x 1/2” Phillips head machine
screws in each End Panel, leaving approximately 1/8”
of thread exposed. See
Figure 1 .
3. With two people, carefully position the steel shelf
over the screws. Note: install the shelf with the 1/16”
corner notch toward the back. Drop the shelf in place
and tighten the screws.
Maximum Shelf Loading
The recommended maximum loading for most shelf
components is 300lbs regardless of shelf width. If more than
one shelf is installed on a pair of end panels, the maximum
load per pair of end panels is not to exceed 300 lbs.
Heavy Duty Shelf Supports (#8161X) can be purchased
separately to increase the weight capacity of the shelf.
See page G-9 for details.
Steel Hook-On Shelving
Full frame
1.00 spaces
R.H. End
#10-24 x 1/2” Phillips
head screw
Slotted
standard
Figure 1
1/8”
Shelf
Screw
End panel
LB25
H o o k - o n S h e l v i n g
C o m p o n e n t s
technical furniture
Upper Shelf
Tower Shelf
Electronics Shelf
General Purpose
Shelf
Mini Electronics/Telephone
Shelf
F-1