Eaton LMS, Installation Manual, Page: 124 / 202

R a c k M o u n t S h e l f
( c o n t . )
ROLL-OUT SHELF INSTALLATION
NOTE : The Roll-Out is equipped with “ Lock Out
Slides ” and a “ Front Disconnect ” chassis member for
your convenience during assembly to the Rack Module.
1. Assemble the Slide sections onto the Rack Module rails.
Slip the
Mounting Brackets behind the screw head of
the Clip Nut. See Figure 4 .
2. Snug the Clip Nut screws enough to retain the Slide, but
still allow it to move in and out.
Do not tighten .
3. Tighten the
Rear Mounting Bracket to the Slide screws
now (not the Clip Nut screws).
4. Close the two sections of the assembled Slide.
Slide the shelf with the disconnect members into the
mounted section. See
Figure 5 .
Push the shelf in until there is a click
Now extend it to its full length.
Push it in again until it is fully closed (the ends of the
three slide sections are even). The last two inches may
bind; just push. It should now slide in and out freely.
5. Now tighten the Clip Nut screws or leave them snug.
6. To remove the shelf and chassis rail, refer to
Figure 6 .
Figure 4
Mounting
bracket
Clip nut
Screw
head
Rail
Slide to bracket
screw
.50
.62
.50
.62
.62
4 Hole group
See NOTE at Step 1
Figure 5
Figure 6
Shelf
Disconnect
member
Slide
Push in
R.H. Slide
R.H. Chassis
member
82158
technical furniture
K-21