87570
technical furniture
B-2
L M S F o u n d a t i o n s
( c o n t . )
FRAME ASSEMBLY - INITIAL SECTION
1. Lay one
End Upright
on the floor as shown in
figure
1
.
2. With two people, attach each
Cross Tie
to the End
Upright with four 1/4”-20 x .75” hex washer head
thread cutting screws.
NOTE
: Attach the Cross Ties with the two smaller
dia. holes (.260 dia.) in the end plates toward
front of the unit.
Tighten all screws securely.
Figure 1
Cross ties
End upright
(L.H. shown)
End plate
Smaller dia. holes
toward front
1/4”-20 x .75” hex
washer head thread
cutting screws
NOTE
: If a single free standing unit is being assembled, (1) left hand and (1) right hand
End Upright
will be used.
If add-on sections are part of the installation,
Intermediate Upright(s)
will be used with the left and right
hand End Uprights. The End Uprights are placed at each end of the installation.
End Upright - L.H.
End Upright - R.H.
Intermediate
Upright
Corner Post With
Standards Assembled
Intermediate
Standards
Cross Ties
Frame Components
Summary of Contents for LMS
