![background image](http://html1.mh-extra.com/html/east-tester/et3325/et3325_user-manual_3447938011.webp)
10
2.1 Basic Waveform Setup
2.1.1 Sine wave setup
Press
and operation menu of sine wave will be displayed at the bottom of the screen.
Channel basic information is displayed on the upper left, including channel switch, output
impedance and name of current waveform. Set output waveform of sine wave through its
operation menu.
Parameters of setup sine wave include frequency/cycle, amplitude/high-level, offset/low-level and
phase. Different sine waves are obtained through alteration of these parameters. As shown in
Figure 2-1, select Frequency in the operation menu and cursor will be in the location of frequency
parameter in the parameter display area, in which user could alter the frequency value of sine
wave through numeric keypad, direction keys or knobs.
Figure 2-1 Display Interface of Setup of Sine Wave Parameters
Table 2-1 Sine Waveform Menu Description
Functional menu
Setup
Description
Frequency/cycle
——
Set waveform frequency or cycle
Amplitude/high-level
——
Set waveform amplitude or
high-level
Offset/low-level
——
Set waveform offset or low-level
Phase
——
Set initial phase of sine wave
Note
: 1. The in-phase in the operation menu is applicable to the synchronization in
TWO/25MHZ-channel output only. It is unnecessary for single-channel waveform.
2. The “
——
” in setup column represents no setup item, hereinafter inclusive.
Set output frequency/cycle