39
2.4 Burst Waveform Setup
Burst key can provide users with burst output of various waveform function, and it can output
waveforms of specific number (N-cycle burst) continuously; when applying to external gate
signal (gated burst), any wave function (except noise and DC) can be used.
Press
to set the output waveform parameters in burst mode by operating the burst
operation menu.
Set N-cycle burst
Press
→ Type→ N-cycle and enter the interface as shown in Figure 2-28.
Figure 2-28 N-cycle Burst Setup Interface
Table 2-19 N-cycle Burst Parameter Setup Menu Description
Functional menu
Setup
Description
Types
N-cycle/infinite/g
ated
Select burst output type: N-cycle
Signal source
Internal/external/ma
nual
Select Trigger Source
Internal: select internal trigger source
External: select external trigger source, use [Ext Trig] connector
on rear-panel
Manual: select manual trigger, and each time you press Trig, a
burst will be output, and a continuous press of the key will trigger
the signal generator once again.
Cycle number ——
Set the cycle number of each N-cycle burst
Period
——
Set the burst period
Phase
——
Set the burst initial phase
