![background image](http://html1.mh-extra.com/html/east-tester/et3325/et3325_user-manual_3447938012.webp)
11
1. Press
→
frequency to set frequency parameter value.
The displayed frequency is either the power-on default value or the frequency previously selected.,
Use the current value if the frequency value is valid for the new waveform when changing
parameters. To set waveform cycle, press the softkey of Frequency once again and switch to the
Cycle softkey (current option is in inverse display).
2. Enter the desired frequency value.
Use the numeric keypad to enter the desired parameter value. Select the unit desired by frequency
and press the softkey corresponding to the desired units. Or use left-right key to specify the digit
of parameter value to be amended and use knobs to alter the digit.
Figure 2-2 Input Frequency Parameters
Note:
To input value through numeric keypad, use left direction key for backspace to delete
previous digit; press the cancellation key to cancel digit input for misoperation.
To input value through knobs, use direction keys to alter the digit with the subscript of
horizontal bar for tracking. Then turn the knob to alter the digit to obtain the desired value.
Set output amplitude
1.
Press
→
amplitude to set the parameter value of amplitude.
The displayed amplitude is either the power-on default value or the amplitude previously selected.
Use the current value if the amplitude is valid for the new waveform when changing parameters.
To use high/low level to set amplitude, press the softkey of Amplitude or Offset once again and
switch to the softkey of High-level and Low-level (current option is in inverse display).
2. Enter the desired amplitude
Use numeric keypad or knobs to enter the desired parameter value. Select the unit desired by
amplitude and press the softkey corresponding to the desired unit.