Quick Start Guide:
QNET Physics and Dynamics
Check Components and Details
STEP 1
Make sure your QNET Physics and Dynamics experiment includes the following components:
3
Additional Components Required
Install LabVIEW and Add-Ons
STEP 2
STEP 3
To complete your QNET Physics and Dynamics board setup, you will also need the following hardware:
Make sure the following versions of LabVIEW™ and required add-ons are installed:
1. LabVIEW™ 2012 or later
2. NI DAQmx 9.5.5 or later
3. NI ELVISmx 4.4 or later
4. LabVIEW™ Control Design and Simulation Module 2012 or later
1. Quanser QNET Physics and
Dynamics board, including:
a) Two pendulum rods
b) Coupling
c) Sliding mass
d) Free pulley
e) Two 100g and two 50g free weights
2. Table Tennis Ball
3. Anchor Screws
4. Hex key
5. Extension spring
6. Cable
Note:
The QNET curriculum resources are
available for download at www.ni.com/qnets
1
2
1. NI ELVIS II or NI ELVIS II
+
workstation
2. +5VDC / 5A, +15VDC / 2A,
-15VDC / 0.8A Power Supply
3. USB Cable
Note:
All references to NI ELVIS II in
this guide apply to both NI ELVIS II
and NI ELVIS II
+
devices.
3
2
1
1a
1c
1d
1b
1e
4
6
5
