EAE RCU2018, Product Manual

Page: 44 / 81

Product Manual RCUXXYY
EAE KNX Room Control Unit
RCUXXYY PM R1.0
©
EAE Technology www.eaetechnology.com Page 43 / 80
The output group switch remain in their current state.
▪
Set the parameter to “ up ”;
After the ETS programming, the actuator raises the blind.
▪
Set the parameter to “ down ”;
After the ETS programming, the actuator lowers the blind.
▪
Set the parameter to “ stop ”;
After the ETS programming, the actuator stops the blind movement.
▪
Set the parameter to “ position 1,2,3,4 ”;
The blind move to a present position. The positions are set in the “ X - Position/Present ” tabs .
▪
Set the parameter to “ approach position ”;
The blind can travel to an approach position specified by other parameters. Other
parameters are;
Position height i n [0…100]
(0% = top; 100% = button)
Position slat in [0…100]
(0% = top; 100% = button).
This parameters are configured the blind height and slat position. If the “Mode of operation”
is selected “venetian blind” , “Position slat in [0…100]” parameters are visible.
Behavior bus voltage return *no reaction
up
down
stop
This parameter can be used to configure the blind behavior after bus voltage return.
▪
Set the parameter to “ no reaction ”;
The output group switch remain in their current state.
▪
Se t the parameter to “ up ”;
After the bus voltage return, the actuator raises the blind.
▪
Set the parameter to “ down ”;
After the bus voltage return, the actuator lowers the blind.
▪
Set the parameter to “ stop ”;
After the ETS programming, the actuator stops the blind movement.