Product Manual RCUXXYY
EAE KNX Room Control Unit
RCUXXYY PM R1.0
©
EAE Technology
www.eaetechnology.com
Page 16 / 80
This parameter can be used to enable/disable manual control. If manual operation is enabled,
connected load can be controlled via the corresponding channel button on the device.
▪
Set the parameter to “enable”
This selection is used to enable manual operation.
▪
Set the parameter to “disable”
This selection is used to disable manual operation.
Reset manual operation to KNX operation
*via push button
automatically and via push button
This parameter determines how long manual operation remains activated.
Time for automatic reset
in s[10…6000]
10…
*300
…6000
Manual operation remains activated until the adjusted time is up or deactivated by button manually.
Device alive operation active
*no
yes
This object is used to report that device is still alive and connected to KNX line. (Heartbeat) If alive
telegram is not received, device may be defective or KNX cable can be disconnected. If parameter is
selected "yes", following parameters come up.
In operation bit
0
*1
Telegram value can be selected as “1” or “0”.
In operation send interval
1…
*300
…65535
Telegram value is sent cyclically according to time interval.
Transmission delay [2…255s] after bus
voltage return
*
2
…255
The parameter defines the behaviour of the actuator at a bus power return. The transmission delay
time determines the period between bus voltage recovery and the point after which telegrams can
be sent.
Telegram limit active
*no
yes
Telegrams which are sent by the gateway can be limited with this parameter. If “yes” is selected,
following parameters come up.
Telegram limit period
50ms…*
10s
…1dk
The limit period can be selected via telegram limit period parameter.
Max. number of transmitted telegram
1
…*
20
…255
Maximum number of telegrams can be sent freely within a period.
NOTE:
If the value of the object cannot be sent in the time of a period. The object is buffered for the
next period time. The buffered object will be updated if the object value is updated.
