E-Swin WE-O, User Manual, Page: 29 / 64

29
y
STEP 4
DELIMIT THE AREA TO BE FLASHED
In order to ensure an optimum hair removal session,
pen
pencils are
supplied. Using these accessories, it is possible to mark out the area which
is to receive flash treatment directly on the skin.
• Mark out the area to receive flash treatment using the
pen
, marking out
parallel strips over large areas.
• Mask any beauty spots using the
Patches
.
• After applying a thick layer of the
gel
to the entire area which is to receive
flash treatment, move the applicator along the marked-out zone (see next
page for instructions on the execution of flash treatment).
• The positioning of the applicator will leave a slightly visible imprint in the
gel
, thereby indicating the area which has already been treated. In this
way, from one flash to the next, it is easy to distinguish an area which has
already received flash treatment from one which has not. An overlap of
approximately 1 mm is possible.
• If necessary, use the
stop
plate to mask a substantial area which is not
to receive flash treatment (tattoos, etc.).
If flash treatment is to be applied to a large area, do not spread
gel
over the entire area from the outset, as it will dry out
and the effectiveness of its optical transmission properties will be impaired. Apply the
gel
progressively as you move over
the area concerned. Under no circumstances must
gel
which has been used on the skin and received flash treatment be
recovered and reused on another area. The repeated application of flash treatment to the
gel
is liable to modify its optical
characteristics.
NOTE:
• Ensure that the
Gel
is applied in a generous layer.
•
Gel
must never overflow into the interior of the mobile head of the
device.
•
Gel
must never be applied below the
stop
plate.
NOTE:
The
pen
work pencil, the
Gel
, the self-adhesive
Patches
, the
Stop
protection plate and the
Mask
glasses to
be used must be those supplied with your . The use of any other product may cause skin burns and will invalidate the
guarantee for your device.
NOTE:
With each flash, the zone treated corresponds to the area covered by the end of the optical guide, or 3.75 x 2 = 7.50 cm
2
.
REMOVING HAIR WITH