E-Swin WE-O, User Manual, Page: 27 / 64

27
• Set the required power level (screen E6 ). Once the previous settings have been selected,
the power gauge level for the flash will appear. The arrows can be used to increase or
decrease the power of the flash to be emitted. Once the power level has been deter-
mined, press on the validation icon on the right-hand side. The power level must be
selected according to the sensation reported by the client, and in accordance with the
principles described below.
• Unlock the safety features (screen E7
). This procedure confirms that:
- Both you and your patient are wearing the
Mask
glasses, on a compulsory basis, throu-
ghout the session.
- The
gel
is applied to the entire area to be treated.
- You are not using in certain physiological or medical contexts (pregnant women,
persons taking photosensitizing medications, etc.)
- You are not using the before the end of the necessary waiting period, on skins
which have recently been sunburnt.
- You have read the instruction manual before proceeding with the session (specifically
warnings and precautions for use).
- You have ensured that there can be no potential projection of water onto . Once all
the precautions have been validated, press on the validation icon on the right-hand side.
• Validate the selected settings (screen E8 ). This screen permits the review of options
selected by the user. Validation is completed by pressing on the “tick” icon. At any time,
it is possible to modify a setting by pressing on that setting, or to return to the previous
menu using the arrow on the bottom left-hand side.
E6
E7
E8
NOTE:
will not generate any flash until you have released all the safety functions by pressing on each of the safety
icons.
IMPORTANT:
• The default power level will be set at its base value. This value permits the achievement
of high-quality results for the majority of users, with optimum safety in 100% of cases.
Increasing the power level of
will have the following consequences:
- An enhancement of the results obtained.
- An increase in skin sensation at the time of the flash treatment.
- An increased risk of redness, or even burns on highly pigmented (dark) skins after
a session.
• Always start with a test using the base setting (the default setting on ), then
increase progressively by increments of one level until the required power level is
achieved. Administer a flash, then wait for 5 minutes after the flash before appraising
the skin reaction. In the absence of any skin reaction, flash treatment may be applied
to the entire zone required, or the power level may be increased by a further increment
and the reaction re-observed.
• The darker the skin receiving flash treatment (whether naturally or by tanning), the
greater the care to be taken when increasing the power level.
REMOVING HAIR WITH